Release Date: 21/03/2008
The Official release is ready in our download area http://sarunasoftware.com
Please follow the instructions careful on the above page.
The Update Client is launched after HWK Support Suite install, if you cancel without making the update, you can run the Update Client again, by selecting the shortcut on the Start Menu:-
If the HWK is a "TRIAL" or affected by 3rd party tools, this software may not work properly, so use at your own risk.
NOTE: Support Access is via the software modules only, download managers have been disabled.
1. New BB5 products:
N82-2,N95-2 8G,N95-6 8G,6301,6301b,6500c-5,N95-4,E51-2)
2. ISM flashing support for BB5 products.
3. Improved DCT4/WD2 Flash Loaders version display.
4. Fixed BB5 PM file open bug.
5. Improved Extended PHONET messages handling.
6. Store of Ext.VPP setting in INI file.
7. Support of new Flash Chips.
8. Fixed CNT flashing for 7370 and 6151.
9. Flash Update pack (184.108.40.206662) added.
Do not use external VPP adapter with RX2 enabled cables, since this will put VPP direct to RX2 and its possible to KILL the phone. This has always been the case with 7 pin cables, but from this release 7 pin cables are supported by UFS+HWK.
1. KG280, KP200, KP202, MG280 support added.
E2P unlock fixed for E420,E428...
Implemented MSL calculation, allows direct unlock
without E2P corruption and shows correct codes.
Rebuild of corrupted Master Key during wrong unlock.
IMEI rebuild for new models (Sysol3)
Implemented MSL calculation, allows direct unlock, and
show correct codes, without any data lose or setting to
default values of MSL, BTID, IMEI or Radio settings.
E2P Sections Read/Write introduced (compatible with TAT)
IMEI and BTID rebuild.(Imei option for Swift_1 only now)
Fixed bug of 0 length TFS files flashing (affected:
java appletts in D880, E200, E250, G600, M610 products)
E2P(hee)sections R/W allows to transfer calibration data,
radio setttings, etc. from product to product, without
damage to other vital data, unlike E2P or FULL clone.
Or allows to Read-Edit-Write well known values.
Access to some sections can be denied by firmware, or
can have different values dependand on firmware version.
In case of protected or none existing section will have
result length of 0 or lose of TAT mode.
Many thanks to all those who have supported us!!!